How To Get Wrinkles Out Of Area Rug

Rugs are a common item found in homes. It come in all different shapes, sizes, colors, and fabrics. Rugs with rigid rubber backings can get wrinkled if pushed against or under furniture. Sometimes, no matter how hard you pull, smooth, and clean the rug, you will not be able to smooth out creases and restore the rug to the condition it was in when it was new. This usually happens because you are using the wrong methods to smooth out the creases. In this article, we will discuss how to get creases out of rugs.

Furthermore, most professionals need to fold or roll the pieces to fit their trucks or vans to transport rugs around your home. However, this can leave the rug with wrinkles or creases in unwanted places, and sometimes these errors will still be visible after installing the rug. To get creases out of rugs and carpet fibers, you will need to re-tighten them using the same techniques that installers use to install carpet while flattening the surface thoroughly. Some of these methods have been highlighted below.

How to Get Creases out Of Rugs: The tools needed

Creases on rugs can be more of an eyesore — they're a tripping hazard. Every time a rug is rolled up and moved, a crease can develop, which seems to be a force to be reckoned with. Fortunately, creases in rugs are as permanent as we allow them to be. Several easy methods will have rugs lying back in no time. And for this, you'll need the following tools:

Spray bottle
Blow dryer
Towel
Carpet tape
Rug stretcher
Knee kicker
Heavy furniture
Steam iron

How to Get Creases out Of Rugs: The best methods

Rugs create creases and marks because of the feet that run over them, furniture, and daily use. Crumpled rugs not only take away a little of the look but are also dangerous if someone trips. It is essential to take care of the folds as they appear. Persistent folds are more challenging to remove and eventually compromise the quality of the rug. This can be corrected using some methods such as:

Reverse fold

A new rug may come with folds and dents due to transport between the store and your home. Rolling up and unrolling a new rug correctly helps prevent these folds. Lay it on the floor and run your hand over it to determine which side the crease should go to. Roll the rug as tightly as you can with the crease facing you. Try to keep it as straight as possible. Backroll slowly, softening with your hand. Calling a friend at this time can be quite useful.

Be careful when using this method; some rug liners are not very flexible. If you hear a crackling noise, stop immediately. Forcing the cover could damage the rug backing.

learn More: How To Lay Vinyl Flooring On Floorboards

Weights

Placing books and other objects on crumpled areas helps smooth them and makes the rug more beautiful and uniform. Stretch the folds and place a book or other heavy object in place. A book works because of its straight surface. Place several books on top of the other to increase the weight, leaving them in place for a few days. If the crease is still evident, turn the rug upside down and gently spray the rug's wrinkled area with water. Put the weights back on and leave in place for another day or two. Some thicker rug types may require longer days, though. In the case of this rug type, it would take about ten days of added weight instead of an estimated three weeks of regular use and vacuuming.

Sunlight

If the weather cooperates, place the rug in direct sunlight for an hour or two. An ideal temperature of 70 to 85 degrees Fahrenheit will encourage the creases to relax naturally. Lay your rug on a clean concrete slab such as your patio or driveway. Do not use this method for carpets with dyes sensitive to the sun, and never leave the rug out overnight.

Rug tape

Rugs tend to slide on wood floors, and this causes them to fold and accumulate creases in different places. To get creases out:

Place a few rug tape pieces under it to keep it in place and prevent these dents.
If the rug is already wrinkled, stretch it as far as possible around the wrinkled spot and place the tape underneath.
Place the rug flat back on the floor and continue to smooth it with your hands.

Learn More: How To Remove Orange From Wood Floors

Ironing

Ironing is one of the best ways to remove stubborn creases on rugs. Ed w ard Morrison Answered on November 15, 2018, "To remove the creases and keep the rug lying flat; you simply need to use two items that are most likely already in your home" this includes a towel and iron.

For this, place a thick towel over the creased area and lightly moisten it using a spray bottle or the steam from the iron itself. Set the iron on a high setting and apply it to the towel.

Next, apply firm and even pressure with it downwards.

You can also use a steam cleaner if the rug is more wrinkled. Next, hang it on a clothesline in the sun, after the process, to dry.

Using a carpet stretcher and a knee kicker

A rug can develop wrinkles or curling if installers do not give it time to acclimatize before installation or not stretch properly. Heavy traffic can also make it loosen and crease up. Once the wrinkles begin, address promptly, or it will quickly worsen, as shoes catch more easily on loose carpet. The procedure here involves re-stretching the rug. And to do that, you will need to rent a carpet stretcher and a knee kicker. Both tools are available at an outlet supply center or rental building.

Read More: How To Install Wood Trim Without Nail Gun

Instructions

Put all the furniture on the rug in an adjoining room. For the stretching to be effective, the rug must be completely uncovered. Furniture dents may also occur if this process is skipped.

Remove any metal transition stripes or edges to which the rug is attached. You can usually do this by prying up with a pry bar and pulling the nails with a hammer or pliers. Be careful not to bend the metal. You don't have to remove any baseboards as well.
Pull the rug from the tack strip in the corner of the room closest to the wrinkled section. To do this, grasp the corner of the rug with the pliers and pull it towards you. Keep pulling several feet along both walls and fold the mat behind.
Adjust the teeth' depth on the rug stretcher by turning the screws on the spacer bar with a screwdriver. They should be long enough to bite into the rug pile without penetrating the backing and coming into contact with the under padding. If they are too long, it could break the filling underneath.
Place the head of the gurney face down on one foot from the wall towards which you need to stretch the rug and anchor the feet against the baseboard on the other side of the room. Angle the table slightly towards the corner of the room.

Now;

Gently pull the handle on the stretcher to stretch the rug.
Reposition the stretcher as needed to remove creases from the center of the rug. When the rug is flat, use the knee kicker to reset it over the tack strips.
Work your way from the center of a wall to the corner, positioning the kicker's head from the knee a few inches from the wall.
Keep pushing with your knee until the creases are gone.
If your rug stretched more than an inch or two, you'd need to trim the excess from the edges before resetting on the tack strips. Use a utility knife or rug cutting knife for this step.
Operate the lever on the rug, stretcher slowly and smoothly. The tool is strong enough to tear the rug.

Steam

If other remedies prove unsuccessful, consider steaming the rug. This should be done by a carpet professional. It will accurately assess whether the rug is wrinkling from improper storage or suffers from a structural defect. Unless the carpet is less than one year old, it will likely cost you over $100 and up, depending on the severity of the ripples and any other work that needs to take place (moving furniture, opening nearby seams and re-seaming, etc.) If you decide to steam the rug yourself, place a white cloth over the area to be steamed, and do not keep the steam in one place for more than 30 to 45 seconds. Prolonged exposure to a high steam setting can darken the yarn of the rug.

How to Get Creases Out Of Rugs: FAQ

Is there any way to get the crease out of the area rug?

Yes. As earlier highlighted, you can get the crease out of the area rug through the following ways:

Reverse fold
Sunlight
Rug tape
Ironing
Steaming

How to Remove Creases Effortlessly from a Cowhide Rug

Cowhide rugs are generally distinctive individual pieces and an excellent addition to any style of home furnishings. To remove creases effortlessly, do use the following steps:

Place a towel under your cowhide rug on the floor. The purpose of having the towel is to protect the rug from any possible deterioration the heat from the iron would cause.

Connect the iron and set it to the medium heat rating.

Place a flannel cloth on the cowhide rug and iron above the creases.

Ensure the iron moves quickly over the rug, as only a little time is needed to remove the creases.

Why New Rugs are Wrinkled and Creased

New rugs are usually wrinkled and creased because of the methods used to package and transport them.

Conclusion

In conclusion, creases and wrinkles are common conditions caused by the carpet's folding for storage or transport. Fortunately, it is not a permanent condition. There are several remedies to smoothen these wrinkles, and these have been highlighted above.

Read More: How to Clean Polypropylene Rug